Allegro EDM PCB Librarian

In this course, you learn to create schematic libraries for Allegro^® Design Entry HDL and footprint libraries for use with the Allegro PCB Editor. About 75% of the course time is focused on front-end schematic library development, and the remaining 25% is spent on back-end footprint creation.

This class is very similar to the Allegro PCB Librarian course except in this class you use Allegro Engineering Data Management (EDM) to run the library tools instead of the Project Manager. You create a library project area for building schematic symbol models as well as flash, padstack, and footprint models.

Allegro PCB Editor footprint creation is also covered in the Allegro PCB Editor course. See the list of Related Courses below.

After completing this course, you will be able to:

DE HDL Library Development

• Introduction
• Creating a Library Project
• Using the Schematic Symbol Model Flow
• Using the Part Flow
• Building a 74LCX125
• Building a Resistor Network
• More Part Building
• Advanced Skills

PCB Editor Library Development

• Introducing the PCB Model Flow
• Package Symbol Wizard
• Custom Padstacks
• Mechanical Symbols
• Edge Connectors
• Debugging Problems

There are no prerequisties for this course.

• Allegro Design Entry HDL Basics
• Allegro Design Entry HDL Front-to-Back Flow
• Allegro PCB Editor Basic Techniques

Please see course learning maps at this link for a visual representation of courses and course relationships. Regional course catalogs may be viewed here.