Home > Community > Forums > IC Packaging and SiP Design > How to connect traces of different nets?

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 How to connect traces of different nets? 

Last post Fri, Feb 22 2013 4:16 AM by oldmouldy. 1 replies.
Started by clifton 21 Feb 2013 07:01 PM. Topic has 1 replies and 9925 views
Page 1 of 1 (2 items)
Sort Posts:
  • Thu, Feb 21 2013 7:01 PM

    • clifton
    • Not Ranked
    • Joined on Wed, Aug 11 2010
    • Posts 1
    • Points 20
    How to connect traces of different nets? Reply

    Hi All

    I need to connect traces of different nets, say net A & B at bottom layer, without DRC in SPB16.5.

    Is there a property setting that I can use for this purpose? Or there is a waiver setting in CM?

    Thank you in advance for the guidance.

     Clifton

    • Post Points: 20
  • Fri, Feb 22 2013 4:16 AM

    • oldmouldy
    • Top 10 Contributor
    • Joined on Tue, Jul 15 2008
    • Woking, Surrey
    • Posts 1,371
    • Points 23,350
    Re: How to connect traces of different nets? Reply
    Assign a NET_SHORT property, Pin or Via Pin is best assignment, Shape assignment isn't great, see the propref.pdf in the doc\propref directory of the installation. This will "waive" the DRC for the shorted nets. You can assign this to a Pin in the Schematic and flow this to PCB Editor if you need to document this in the schematic.
    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by clifton at 21 Feb 2013 07:01 PM. Topic has 1 replies.