Home > Community > Forums > PCB Design > DXF Output Control? Trying to Import to Microwave Office

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 DXF Output Control? Trying to Import to Microwave Office 

Last post Thu, Nov 15 2007 12:50 PM by archive. 0 replies.
Started by archive 15 Nov 2007 12:50 PM. Topic has 0 replies and 789 views
Page 1 of 1 (1 items)
Sort Posts:
  • Thu, Nov 15 2007 12:50 PM

    • archive
    • Top 75 Contributor
    • Joined on Fri, Jul 4 2008
    • Posts 88
    • Points 4,910
    DXF Output Control? Trying to Import to Microwave Office Reply

    Hello,

    I am trying to export a DXF that I will then import into Microwave Office for an electromagnetic analysis.  MO supports DXF import, but not of POLYLINE entities with width greater than zero.

    Is there a way to get Allegro to use only certain DXF entities when generating a DXF file?

    Better yet, if someone has done this (Allegro out -> Microwave Office in), how did you do it?

    With just the POLYLINE defaults out of Allegro, I get a bunch of POLYLINEs that are centered at the right place in the design, but the width information is not there.

    Thanks,
    Len


    Originally posted in cdnusers.org by gleaming_alloy_aircar
    • Post Points: 0
Page 1 of 1 (1 items)
Sort Posts:
Started by archive at 15 Nov 2007 12:50 PM. Topic has 0 replies.