Home > Community > Forums > PCB Design > Cross Probe between Concept and Allegro during placement

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Cross Probe between Concept and Allegro during placement 

Last post Wed, Nov 8 2006 11:07 AM by archive. 0 replies.
Started by archive 08 Nov 2006 11:07 AM. Topic has 0 replies and 613 views
Page 1 of 1 (1 items)
Sort Posts:
  • Wed, Nov 8 2006 11:07 AM

    • archive
    • Top 75 Contributor
    • Joined on Fri, Jul 4 2008
    • Posts 88
    • Points 4,950
    Cross Probe between Concept and Allegro during placement Reply

    Hello all,

    I thought at one point you were able to cross probe between Concept and Allegro during placement.   In other words,  you would be able to select a component(s) in Concept and drag it over to Allegro for placement.  This would allow one click placement in Allegro of the primary component and all its associated components driven by its location in Concept.

    If I enter Place Manual in Allegro and select component in Concept it will check the components for placement so I can place them one at a time but I was looking to use the components relative location on the schematic for placement in Allegro.

    Thanks in advance,
    Mike Catrambone
    UTStarcom, Inc.


    Originally posted in cdnusers.org by mcatramb91
    • Post Points: 0
Page 1 of 1 (1 items)
Sort Posts:
Started by archive at 08 Nov 2006 11:07 AM. Topic has 0 replies.