Home > Community > Forums > PCB Design > generate gerber files

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 generate gerber files 

Last post Wed, Feb 8 2006 10:47 PM by archive. 4 replies.
Started by archive 08 Feb 2006 10:47 PM. Topic has 4 replies and 950 views
Page 1 of 1 (5 items)
Sort Posts:
  • Wed, Feb 8 2006 10:47 PM

    • archive
    • Top 75 Contributor
    • Joined on Fri, Jul 4 2008
    • Posts 88
    • Points 4,930
    generate gerber files Reply

    Hi all,

    I want to learn to generate output files (gerber, nc drill, etc) so that my board can be manufactured. I don't know from where to start.

    Is there any tutorial about generating output files for Allegro 15.2?
    And how to check if the output files are correct?

    Thanks.


    Originally posted in cdnusers.org by damian_s
    • Post Points: 0
  • Thu, Feb 9 2006 6:15 AM

    • archive
    • Top 75 Contributor
    • Joined on Fri, Jul 4 2008
    • Posts 88
    • Points 4,930
    RE: generate gerber files Reply

    There is documentation within the Allegro environment that describes how to create artwork files and nc drill data. Look under the Allegro PCB Editor User Guide for the section "Preparing Manufacturing data".

    You will learn there that the artwork files can be imported back into Allegro for review.

    Hope this helps.

    Charlie


    Originally posted in cdnusers.org by cdavies
    • Post Points: 0
  • Thu, Feb 9 2006 6:26 AM

    • archive
    • Top 75 Contributor
    • Joined on Fri, Jul 4 2008
    • Posts 88
    • Points 4,930
    RE: generate gerber files Reply

    You may want to attend an EMA sponsered webinar on Feb 16; Preparing Design For Manufacturing.

    http://www.ema-eda.com/training/webinar.aspx


    Originally posted in cdnusers.org by EdH
    • Post Points: 0
  • Thu, Feb 9 2006 1:09 PM

    • archive
    • Top 75 Contributor
    • Joined on Fri, Jul 4 2008
    • Posts 88
    • Points 4,930
    RE: generate gerber files Reply

    I would also like to learn about test preparation (testprep) beyond what the User Guide has to offer in the Preparing Manufacturing Data for Allegro 15.5

    Thanks,


    Originally posted in cdnusers.org by mihaii
    • Post Points: 0
  • Thu, Feb 9 2006 1:23 PM

    • archive
    • Top 75 Contributor
    • Joined on Fri, Jul 4 2008
    • Posts 88
    • Points 4,930
    RE: generate gerber files Reply

    You should start a new topic for this discussion.

    What specifically do you want to know?


    Originally posted in cdnusers.org by cdavies
    • Post Points: 0
Page 1 of 1 (5 items)
Sort Posts:
Started by archive at 08 Feb 2006 10:47 PM. Topic has 4 replies.