Home > Community > Forums > PCB Design > Setup advisor issue

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Setup advisor issue 

Last post Fri, Sep 15 2006 3:45 AM by archive. 1 replies.
Started by archive 15 Sep 2006 03:45 AM. Topic has 1 replies and 537 views
Page 1 of 1 (2 items)
Sort Posts:
  • Fri, Sep 15 2006 3:45 AM

    • archive
    • Top 75 Contributor
    • Joined on Fri, Jul 4 2008
    • Posts 88
    • Points 4,930
    Setup advisor issue Reply

    Hello Guys,

    Faced a problem with Tool -à Setup Advisor -à Edit cross section that when I updated the specs for single ended nets and then when I switched to “Differential Mode” & entered there values. After that when I again come back to Single ended Mode. I observed that values have been changed. Any one has any solution for that?

    irfan


    Originally posted in cdnusers.org by imaqsood
    • Post Points: 0
  • Tue, Oct 3 2006 2:36 PM

    • archive
    • Top 75 Contributor
    • Joined on Fri, Jul 4 2008
    • Posts 88
    • Points 4,930
    RE: Setup advisor issue Reply

    This is the way the tool works. The values you are entering are purely there for calculation sake. They are not going to control the route behavior. You need to control the actual spacing/widths using the Net_Spacing, and Net_Physical methods.


    Originally posted in cdnusers.org by jbhorner
    • Post Points: 0
Page 1 of 1 (2 items)
Sort Posts:
Started by archive at 15 Sep 2006 03:45 AM. Topic has 1 replies.