Home > Community > Forums > PCB Design > How to use the some set of vias under the top to bottom layers?

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 How to use the some set of vias under the top to bottom layers? 

Last post Sun, Jul 13 2014 8:42 PM by Dhamodharann. 0 replies.
Started by Dhamodharann 13 Jul 2014 08:42 PM. Topic has 0 replies and 85 views
Page 1 of 1 (1 items)
Sort Posts:
  • Sun, Jul 13 2014 8:42 PM

    • Dhamodharann
    • Top 50 Contributor
    • Joined on Tue, Dec 4 2012
    • Coimbatore, Tamil Nadu
    • Posts 123
    • Points 1,685
    How to use the some set of vias under the top to bottom layers? Reply
    Hi..

    For the specific board design the top and bottom layers should been get connected set of arrays.For that option i had tried to use the thieving parameters. In that rectangle type shape has enabled to use it. but when i am try to use other shaped it is not possible.

    Suppose if try to put the vias thieving parameters,In case i want to increase the pad size of via directly means the how is it possible? Can i edit the via pad stack in the thieving parameters.

    Thanks & Regards
    Dhamodharan
    • Post Points: 5
Page 1 of 1 (1 items)
Sort Posts:
Started by Dhamodharann at 13 Jul 2014 08:42 PM. Topic has 0 replies.