Home > Community > Forums > Custom IC Design > Interactive AMS

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Interactive AMS 

Last post Wed, Feb 27 2008 1:27 PM by archive. 0 replies.
Started by archive 27 Feb 2008 01:27 PM. Topic has 0 replies and 1074 views
Page 1 of 1 (1 items)
Sort Posts:
  • Wed, Feb 27 2008 1:27 PM

    • archive
    • Top 75 Contributor
    • Joined on Fri, Jul 4 2008
    • Posts 88
    • Points 4,930
    Interactive AMS Reply

        I am using AMS to simulate the top level of a chip.  I am using 5.1 version of the tools.  Currently I am launching AMS using ADE and running in interactive mode(ie with simvision).  I would like to be able to run for some amount of time and then pause the simulation.  After pausing, I would like to be able to save additional nodes, or create forces for nodes.  I do not want to change any analog parameters.  From looking through the documentation, it seems to say that this cannot be done when using the analog solver and old parser.  I have tried to do this with my setup, and I have not been succesful.  My question is "Is there a method to run AMS in version 5.1 that would allow me to do something like this.  I want to be able to change what nodes are being saved, and what digital nodes are being forced."


    Originally posted in cdnusers.org by markalansummers
    • Post Points: 0
Page 1 of 1 (1 items)
Sort Posts:
Started by archive at 27 Feb 2008 01:27 PM. Topic has 0 replies.