Home > Community > Forums > Custom IC SKILL > How to detect and remove dangling nets in schematic?

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 How to detect and remove dangling nets in schematic?  

Last post Fri, Dec 13 2013 3:49 AM by Andrew Beckett. 1 replies.
Started by ffoo 12 Dec 2013 06:41 PM. Topic has 1 replies and 908 views
Page 1 of 1 (2 items)
Sort Posts:
  • Thu, Dec 12 2013 6:41 PM

    • ffoo
    • Not Ranked
    • Joined on Fri, Apr 5 2013
    • Posts 2
    • Points 40
    How to detect and remove dangling nets in schematic? Reply

    Hi,

    Is there skill codes available to detect and remove dangling nets in schematic?

     

    Thanks.  

     

    • Post Points: 20
  • Fri, Dec 13 2013 3:49 AM

    Re: How to detect and remove dangling nets in schematic? Reply

    I've never written anything to do this - maybe somebody else has. It probably depends on your definition of "dangling"... detecting a wire which isn't connected at all is easy enough, but it gets a little trickier (not impossible though) to detect wires that are only connected at one end. You'd probably have to use dbGetOverlaps to determine if there was something under the vertices of the wires. 

    Regards,

    Andrew.

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by ffoo at 12 Dec 2013 06:41 PM. Topic has 1 replies.