Home > Community > Forums > Custom IC SKILL > How to reconnect the wires after cell replacement?

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 How to reconnect the wires after cell replacement? 

Last post Fri, Dec 13 2013 3:46 AM by Andrew Beckett. 1 replies.
Started by ffoo 12 Dec 2013 06:35 PM. Topic has 1 replies and 795 views
Page 1 of 1 (2 items)
Sort Posts:
  • Thu, Dec 12 2013 6:35 PM

    • ffoo
    • Not Ranked
    • Joined on Fri, Apr 5 2013
    • Posts 2
    • Points 40
    How to reconnect the wires after cell replacement? Reply

    Hi,

     

    I found a very useful skill codes "CCSchangeCells" from the skill library that can do cell replacement. However i have 2 cell symbols which have different footprints. Thus after cell replacement, there are disconnect wires. Is there any skill code that can connect the wires to the pins.  

    • Post Points: 20
  • Fri, Dec 13 2013 3:46 AM

    Re: How to reconnect the wires after cell replacement? Reply

    Maybe this code would be more useful, as it has options to rewire after differences in pin locations? The rest of the thread may be worth looking at too for some guidance on using it.

    Regards,

    Andrew.

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by ffoo at 12 Dec 2013 06:35 PM. Topic has 1 replies.