Home > Community > Forums > Custom IC SKILL > Bindkey to Annotate DC Operating Point

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Bindkey to Annotate DC Operating Point 

Last post Fri, Nov 1 2013 12:10 PM by TaherKotb. 1 replies.
Started by Clidre 29 Oct 2013 04:25 AM. Topic has 1 replies and 2878 views
Page 1 of 1 (2 items)
Sort Posts:
  • Tue, Oct 29 2013 4:25 AM

    • Clidre
    • Not Ranked
    • Joined on Thu, Oct 17 2013
    • Posts 3
    • Points 60
    Bindkey to Annotate DC Operating Point Reply

    I've searched but I haven't found it.

    Do you know if there's a bindkey to annotate the DC Operating Point on the schematic? I'm working with Cadence Virtuoso 6.1.5.

    Thanks!

    Filed under:
    • Post Points: 20
  • Fri, Nov 1 2013 12:10 PM

    • TaherKotb
    • Top 500 Contributor
    • Joined on Wed, Apr 24 2013
    • Posts 24
    • Points 315
    Re: Bindkey to Annotate DC Operating Point Reply

    Hello Clidre,

    You can set your own bindkey configuration through hiSetBindKey() procedure

    Post dc netlist and run, you can write the following command:

    sevAnnotateResults( sevSession( hiGetCurrentWindow() 'dcOpPoints )

    sevAnnotateResults( sevSession( hiGetCurrentWindow() 'dcNodeVoltages ) 

    To bind a key to the annotate function, you can choose the shift+c combination as follows:

    hiSetBindKey( "Schematics" "Shift<Key>c"  "sevAnnotateResults( sevSession( hiGetCurrentWindow() 'dcOpPoints ) " ) 

     

    Best Regards

    Taher 

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by Clidre at 29 Oct 2013 04:25 AM. Topic has 1 replies.