Home > Community > Forums > PCB Design > How to clear DRC of dynamic fillet to diff pair

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 How to clear DRC of dynamic fillet to diff pair 

Last post Wed, Jun 26 2013 1:48 AM by steve. 1 replies.
Started by James Tan 25 Jun 2013 08:47 AM. Topic has 1 replies and 364 views
Page 1 of 1 (2 items)
Sort Posts:
  • Tue, Jun 25 2013 8:47 AM

    • James Tan
    • Not Ranked
    • Joined on Tue, Jun 25 2013
    • Posts 2
    • Points 40
    How to clear DRC of dynamic fillet to diff pair Reply

     I am using dynamic fillet, disallow DRC and my fillets are not able to show on my differential pairs. Due to the physical constraint, the fillets are too close to the other trace of the pair. I can make the fillets appear by allowing DRC on my fillet parameters, but the DRC will show. How do I make the fillets appear without DRC or without waiving the DRCs?

    • Post Points: 20
  • Wed, Jun 26 2013 1:48 AM

    • steve
    • Top 10 Contributor
    • Joined on Fri, Jul 18 2008
    • Woking, Surrey
    • Posts 1,168
    • Points 18,955
    Re: How to clear DRC of dynamic fillet to diff pair Reply

    You don't have to fillet the whole board with the same rules.  but it's either All (Dynamic) or you can select by Window or pick net, pin. There is also a Pin property No_Fillet which would leave the pin without a fillet. You can then darw it in yourself so It doesn't produce a DRC. You can also tweak the size etc of the fillet from the Gloss - Parameters menu.

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by James Tan at 25 Jun 2013 08:47 AM. Topic has 1 replies.