Home > Community > Forums > PCB Design > Hanging issue

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Hanging issue 

Last post Thu, Jun 6 2013 6:13 AM by C Shiva. 4 replies.
Started by C Shiva 05 Jun 2013 01:44 AM. Topic has 4 replies and 689 views
Page 1 of 1 (5 items)
Sort Posts:
  • Wed, Jun 5 2013 1:44 AM

    • C Shiva
    • Top 50 Contributor
    • Joined on Tue, Jul 15 2008
    • Bangalore, Karnataka
    • Posts 165
    • Points 3,440
    Hanging issue Reply

    Hi All,

    In our present board while routing ground (GND) net, the tool getting slow and taking time to route every segment. But for other nets with VCC it working fine. There is no properties attached to the GND net. If anyone faced the same, please help to solve the issue.

    Using Allegro PCB Designer v16.6

    Thanks,

    Shiva.

    • Post Points: 20
  • Wed, Jun 5 2013 4:31 AM

    • oldmouldy
    • Top 10 Contributor
    • Joined on Tue, Jul 15 2008
    • Woking, Surrey
    • Posts 1,370
    • Points 23,330
    Re: Hanging issue Reply

    Close the schematic if it is open to prevent cross-probing, there is a Capture user preference to disable cross-probing global nets.

    If the schematic is not open, set a value for the Voltage property for the net.

    • Post Points: 20
  • Wed, Jun 5 2013 11:54 PM

    • C Shiva
    • Top 50 Contributor
    • Joined on Tue, Jul 15 2008
    • Bangalore, Karnataka
    • Posts 165
    • Points 3,440
    Re: Hanging issue Reply

     Thanks for your solution. After setting a Voltage property the problem has solved and it working smoothly.

    • Post Points: 20
  • Thu, Jun 6 2013 2:11 AM

    • oldmouldy
    • Top 10 Contributor
    • Joined on Tue, Jul 15 2008
    • Woking, Surrey
    • Posts 1,370
    • Points 23,330
    Re: Hanging issue Reply
    This issue and Voltage requirement seems to be isolated to 16.6.s010 specifically.
    • Post Points: 20
  • Thu, Jun 6 2013 6:13 AM

    • C Shiva
    • Top 50 Contributor
    • Joined on Tue, Jul 15 2008
    • Bangalore, Karnataka
    • Posts 165
    • Points 3,440
    Re: Hanging issue Reply

     You are right i think. Because if i run the same board file in another system with older version of tool v16.01 without any property, it works fine without any lagging.

    • Post Points: 5
Page 1 of 1 (5 items)
Sort Posts:
Started by C Shiva at 05 Jun 2013 01:44 AM. Topic has 4 replies.