Home > Community > Forums > Custom IC Design > Hysteresis sweep option in DC

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Hysteresis sweep option in DC  

Last post Wed, Jan 2 2013 5:57 AM by Andrew Beckett. 1 replies.
Started by sohaiba 11 Oct 2012 12:25 AM. Topic has 1 replies and 1268 views
Page 1 of 1 (2 items)
Sort Posts:
  • Thu, Oct 11 2012 12:25 AM

    • sohaiba
    • Top 500 Contributor
    • Joined on Mon, Jul 9 2012
    • Islamabad, Pakistan
    • Posts 21
    • Points 375
    Hysteresis sweep option in DC Reply

    Hi,

    I haven't been able to see a Hysteresis plot by using the DC Hysteresis sweep option. I have also enabled the 'DC operating point' option as well. I was expecting to find a negative going plot as well for the device but there is only a single Voltage transfer characteristic curve.

     Following are the settings the Cadence spectre.out shows.

    Important parameter values:
        reltol = 1e-03
        abstol(V) = 1 uV
        abstol(I) = 1 pA
        temp = 120 C
        tnom = 27 C
        tempeffects = all
        gmindc = 1 pS
        hysteresis = on

    Which verifies that hysteresis option is "ON".  I am using MMSIM 11.1 and Cadence 6.1.5. Could you indicate where I could be going wrong?

    Regards

     

     

    Sohaib
    • Post Points: 20
  • Wed, Jan 2 2013 5:57 AM

    Re: Hysteresis sweep option in DC Reply

     No idea - this should work. Please contact customer support.

    Andrew.

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by sohaiba at 11 Oct 2012 12:25 AM. Topic has 1 replies.