Home > Community > Forums > Custom IC SKILL > Connect center lines of two paths together

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Connect center lines of two paths together 

Last post Tue, Nov 3 2009 1:30 AM by Andrew Beckett. 1 replies.
Started by cado 03 Nov 2009 01:20 AM. Topic has 1 replies and 988 views
Page 1 of 1 (2 items)
Sort Posts:
  • Tue, Nov 3 2009 1:20 AM

    • cado
    • Not Ranked
    • Joined on Fri, Oct 30 2009
    • Posts 4
    • Points 95
    Connect center lines of two paths together Reply

    For converting a polygon into a path, first I converted polygon into rectangle using dbLayerTile. Then I converted it into path. In this process, I found that the newly formed paths(parts of the same old polygon) just touch each other. Any Idea on how to make these paths center-line connected?

     

    • Post Points: 20
  • Tue, Nov 3 2009 1:30 AM

    Re: Connect center lines of two paths together Reply

    Rather than doing this via dbLayerTile, perhaps you could use my code from Cadence Online Support Solution 11037248 ?

    Alternatively you could take all your converted paths, and try to match end points, and the alter ~>points on one of the paths to produce the combined point list (and then delete one of the paths). But this will be messy at bends, I suspect, so you may be better off using the code above.

    Regards,

    Andrew.

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by cado at 03 Nov 2009 01:20 AM. Topic has 1 replies.