Home > Community > Forums > Custom IC Design > Ocean Script For MonteCarlo Simulation shows incorrect results

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Ocean Script For MonteCarlo Simulation shows incorrect results 

Last post Wed, Oct 21 2009 12:07 PM by lunren. 2 replies.
Started by lunren 16 Oct 2009 10:52 AM. Topic has 2 replies and 1987 views
Page 1 of 1 (3 items)
Sort Posts:
  • Fri, Oct 16 2009 10:52 AM

    • lunren
    • Top 500 Contributor
    • Joined on Thu, Oct 1 2009
    • Posts 21
    • Points 315
    Ocean Script For MonteCarlo Simulation shows incorrect results Reply

    Hi All,

     My script for montecarlo simulation finished successfully, no error displayed. My script uses for loop so that I can run montecarlo simulation in 5 different corners. I use monteExpr to get simulation results. The results are stored in 5 different directories. However, the results have some problem.

    There are some strange numbers following the correct results. I suspect these strange numbers are process number, so If I change the value of ?saveProcessParams from "t" to "nil", the simulation results are correct. However, this is not what I what. I am wondering what's the problem? Thanks,

     Lunren

    • Post Points: 20
  • Fri, Oct 16 2009 1:27 PM

    Re: Ocean Script For MonteCarlo Simulation shows incorrect results Reply

    I was just about to reply that your question seemed somewhat similar to your previous post. But it seems you've edited the post since you originally posted it so it no longer has the part about getting duplicate information.

    Can you show the "strange numbers" - i.e. what is the output and what is strange about it? Otherwise it's really hard to understand what your problem is.

    Best Regards,

    Andrew.

    • Post Points: 20
  • Wed, Oct 21 2009 12:07 PM

    • lunren
    • Top 500 Contributor
    • Joined on Thu, Oct 1 2009
    • Posts 21
    • Points 315
    Re: Ocean Script For MonteCarlo Simulation shows incorrect results Reply

    Sorry for later reply, recently kind of busy.

     The problem just happened once, and for some unknown reason, I can not repeat it. If this happened again, I will ask you again.

     Thanks and have a good day.

    • Post Points: 5
Page 1 of 1 (3 items)
Sort Posts:
Started by lunren at 16 Oct 2009 10:52 AM. Topic has 2 replies.