Home > Community > Forums > Custom IC Design > How to enable Spectre autosave the results everytime i run it!

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 How to enable Spectre autosave the results everytime i run it! 

Last post Tue, May 19 2009 6:33 AM by sharezhao. 2 replies.
Started by sharezhao 17 May 2009 08:49 PM. Topic has 2 replies and 1035 views
Page 1 of 1 (3 items)
Sort Posts:
  • Sun, May 17 2009 8:49 PM

    • sharezhao
    • Not Ranked
    • Joined on Wed, May 13 2009
    • Posts 2
    • Points 25
    How to enable Spectre autosave the results everytime i run it! Reply

    Dear all! 

    I'm using spectre as simulation tool in vituoso 5141. How can make spectre atuosave the results such as ten last times results? now if I want to see the voltage of some nets of last time, i have to change to former parameters and run it again. That is very inconvenient. So what should i do?

    Thank you!

    Best regards!

    • Post Points: 20
  • Mon, May 18 2009 12:16 PM

    Re: How to enable Spectre autosave the results everytime i run it! Reply

    This .cdsenv setting should do it:

    asimenv.misc  numberOfSavedRuns int    10

    or from SKILL:

    envSetVal("asimenv.misc" "numberOfSavedRuns" 'int 10)

    It's covered in the <instdir>/doc/anasimhelp/anasimhelp.pdf 

    Andrew 

    • Post Points: 20
  • Tue, May 19 2009 6:33 AM

    • sharezhao
    • Not Ranked
    • Joined on Wed, May 13 2009
    • Posts 2
    • Points 25
    Re: How to enable Spectre autosave the results everytime i run it! Reply

    Dear Andrew!

    You are right, Thank you so much. This problem have been annoying me for a long time. You answer is right on the spot. By the way,  "asimenv.misc  numberOfSavedRuns int    10" is in the .cdsinit.  Sincere appeciation !!!

    Best regerds

    • Post Points: 5
Page 1 of 1 (3 items)
Sort Posts:
Started by sharezhao at 17 May 2009 08:49 PM. Topic has 2 replies.