Home > Community > Forums > RF Design > how to update changed netlist ?

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 how to update changed netlist ? 

Last post Fri, Nov 14 2008 2:09 AM by Ejlersen. 1 replies.
Started by Prasanna 13 Nov 2008 08:43 AM. Topic has 1 replies and 2188 views
Page 1 of 1 (2 items)
Sort Posts:
  • Thu, Nov 13 2008 8:43 AM

    • Prasanna
    • Top 100 Contributor
    • Joined on Thu, Oct 16 2008
    • Bangalore, Karnataka
    • Posts 71
    • Points 1,705
    how to update changed netlist ? Reply

     

    Hi there....

     I am placing components in  board. But there has been some changes made in schematic. component  placement is almost over in my board. Now how should i update changed netlist to my board.?

     

    Thanks,

    Prasanna

    • Post Points: 20
  • Fri, Nov 14 2008 2:09 AM

    • Ejlersen
    • Top 10 Contributor
    • Joined on Mon, Jul 28 2008
    • Aalborg, Copenhagen
    • Posts 569
    • Points 10,080
    Re: how to update changed netlist ? Reply

    Hi,

    If you import the netlist inside PCB Editor and remember to check the "always place changed components" flag then the existing placement will be preserved. Even if a package symbol (footprint) has changed it will be placed in the same position (based on the reference designator)

    Also if you do not check 'allow etch removal' then all your existing etch will exist and you can make adjustments to eliminate DRCs that may happen when you import a new netlist.

    Best regards,

    Ole

    Best regards Ole
    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by Prasanna at 13 Nov 2008 08:43 AM. Topic has 1 replies.