Home > Community > Tags > ratsnest
 
Login with a Cadence account.
Not a member yet?
Create a permanent login account to make interactions with Cadence more conveniennt.

Register | Membership benefits
Get email delivery of the Cadence blog (individual posts).
 

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

ratsnest

  • Through Hole, both side routing.

    Hello, it may look stupid question but I am stuck with it. I have a through hole connector on my 2 layer board for hight current (track width 5mm) I would like to rout the track on both layers, of the connector, when i tries to do that the track on one side goes away. and i am not getting tracks on both...
    Posted to PCB Design (Forum) by raul5565 on Thu, May 23 2013
  • Signal will not connect to other line or pad

    Hi, Please give advise why the signals don't want to connect. I tried every setting I found, the lines just do not want to snap to a pin or other line segment. The ratsnets showing not connected even if the line endponits are completely on each other. I replaced the components to be on grid (the...
    Posted to PCB Design (Forum) by Crusty on Tue, Aug 14 2012
  • Rats snap to closest connections while moving parts

    Hello, While moving a part(still attached to the cursor) is it possible to get the ratsnest for the part to snap to the closest connections available in the vicinity? Pawan
    Posted to PCB Design (Forum) by Pawandeep on Tue, May 15 2012
  • Is there a way to make the rat lines of certain nets disappear?

    Say I am placing IC components and I want only to see the signal nets but not the VCC or Ground nets. How can I do this? How can I select certain nets to have invisible rat lines? Thanks in advance. Cheers, Allan
    Posted to PCB Design (Forum) by Allan M on Wed, Apr 4 2012
  • ratsnets

    Hi all, please tell me if it is possible to show only one ratsnet in LayoutPlus 9, like it use in pcb386+ when you clicked "X" on a pad. I have managed to do something near, by clicking the pad with ctrl&shift. the problem is, that after moving the part, the ratsnet dissapears. thank you
    Posted to PCB Design (Forum) by almar on Sun, Mar 11 2012
  • PCB autorouter(spectraa) not converging

    Hi, I am making my first pcb with a xilinx fpga device(256 pin BGA package).I am simply connecting the all I/O's to 4 standard 40 pin connectors.Are padstacks necessary for PCB routing??.I have drawn the schematic in Capture imported it to Layout_Plus and autorouted it. But after 3 hours of autorouting...
    Posted to PCB Design (Forum) by bennyn1 on Thu, Sep 2 2010
  • routing to gnd/pwr planes

    simple question, but I am not sure how to solve it, since I am new to allegro/pcb editor (16.0). I ran autorouter, and it didn't rout any VCC or GND nets to my VCC or GND layers; they just show up as ratsnest, even though the auto router said it completed 100%. here is an image: http://img94.imageshack...
    Posted to PCB Design (Forum) by sharted on Fri, Jun 18 2010
Page 1 of 1 (7 items)