PCB SKILL

Re: route>slide axl-command??

sepiroth — Fri, 12 Jun 2009 00:31:39 GMT

Hi djhutchi,

The provided code as below is work on shoving the clines on via. Can the code be modified so the slided distance can be set? Example, the clines want to be slide ix 100 from its original place.

    axlSetFindFilter(?enabled '("CLINES" "VIAS") ?onButtons '("CLINES" "VIAS"))
    axlSelect()
    axlShoveSetParams(list(1 45 1 1 0 0))
    axlShoveItems(axlGetSelSet())

Re: route>slide axl-command??

djhutchi — Thu, 11 Jun 2009 15:03:03 GMT

Below is a small code segment that uses the axl funcitons to attempt sliding clines to clear DRC violations on vias that were just added:

                                        axlMsgPut("Shoving %d Clines" length(clines))
                                        axlShoveSetParams(list(1 45 1 1 0 0))
                                        unless(axlShoveItems(clines)
                                            axlDeleteObject(via)
                                            axlMsgPut("Via deleted due to Shoving Error")
                                        )

Re: route>slide axl-command??

sepiroth — Thu, 11 Jun 2009 00:08:15 GMT

Hi Ubaid,

Those are the aliases function key. What I looking for is the axl-command that I can use when writing the SKILL programming.

Anyone try to slide the traces by using SKILL programming before?

Re: route>slide axl-command??

ubaid — Wed, 10 Jun 2009 18:48:20 GMT

Shift+F5 (If using <16.0)

Shift+F3 (For 16.X verstions)

Regards,

Ubaid Warsi

route>slide axl-command??

sepiroth — Wed, 10 Jun 2009 09:31:11 GMT

Hi, any axl-command can run the slide (route>slide) function to slide the clines?

If no is there any other alternative way to do it?

Thanks

sepiroth