Home > Community > Forums > Mixed-Signal Design > printing voltages and currents after transient or dc operating point simulations

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 printing voltages and currents after transient or dc operating point simulations 

Last post Sat, Dec 21 2013 12:26 AM by Andrew Beckett. 1 replies.
Started by kawan 14 Nov 2013 09:52 PM. Topic has 1 replies and 6716 views
Page 1 of 1 (2 items)
Sort Posts:
  • Thu, Nov 14 2013 9:52 PM

    • kawan
    • Not Ranked
    • Joined on Wed, Jun 26 2013
    • Posts 14
    • Points 205
    printing voltages and currents after transient or dc operating point simulations Reply

    Is there a way for me to run a simulation and have it write out a text file stating the voltages and currents of all nodes saved?

    The simulation would be a dc operating point or a transient where I specifiy the time for printing. It is exactly like annotating the operating point. I can do this in the ADE window, but do not want to see it graphically.

    results > annotate > dc operating points

     

    Any thoughts?

     

    Thanks

    zakir

    Filed under: , ,
    • Post Points: 20
  • Sat, Dec 21 2013 12:26 AM

    Re: printing voltages and currents after transient or dc operating point simulations Reply

    Zakir,

    The dc analysis has a parameter "write" which will do this (I think it would be OK). I thought that ckptperiod on tran analysis might do the same for transient, but that's effectively obsolete and it didn't do what I was expecting. 

    Regards,

    Andrew.

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by kawan at 14 Nov 2013 09:52 PM. Topic has 1 replies.