Home > Community > Forums > Custom IC Design > ADEXL retry test

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 ADEXL retry test 

Last post Fri, Oct 4 2013 2:17 AM by pdub. 2 replies.
Started by pdub 03 Oct 2013 02:46 AM. Topic has 2 replies and 214 views
Page 1 of 1 (3 items)
Sort Posts:
  • Thu, Oct 3 2013 2:46 AM

    • pdub
    • Not Ranked
    • Joined on Mon, Feb 25 2013
    • Posts 2
    • Points 25
    ADEXL retry test Reply

    How do you control the "retry test" behaviour of ADEXL? Here's the problem...

    A transient sim has a convergence failure near the end of the analysis and ADEXL (I think) is restarting the sim automatically. The original results would have been good enough but I can't view them because the new sim is overwriting them. On the second attempt the sim fails at the same point and this time ADEXL does not retry and I can view the results.

    Any ideas much appreciated - pdub 

    • Post Points: 20
  • Thu, Oct 3 2013 1:11 PM

    Re: ADEXL retry test Reply

    envSetVal("adexl.distribute" "numRetriesOnError" 'int 1)

    I can't remember whether it's sufficient to enter this in the CIW, or whether it must go into the .cdsinit as well (so that the child ICRP processes pick it up) - sorry, don't have time to test right now.

    Regards,

    Andrew.

    • Post Points: 20
  • Fri, Oct 4 2013 2:17 AM

    • pdub
    • Not Ranked
    • Joined on Mon, Feb 25 2013
    • Posts 2
    • Points 25
    Re: ADEXL retry test Reply

    Thanks for your help. Using envGetVal the number of retries was set to 2 so that explains the behaviour.

     Regards, pdub. 

    • Post Points: 5
Page 1 of 1 (3 items)
Sort Posts:
Started by pdub at 03 Oct 2013 02:46 AM. Topic has 2 replies.