Home > Community > Forums > PCB Design > Allegro 3D-Viewer Bottom Component View not correct

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Allegro 3D-Viewer Bottom Component View not correct 

Last post Tue, Aug 27 2013 5:29 AM by steve2fit. 2 replies.
Started by steve2fit 26 Aug 2013 12:06 PM. Topic has 2 replies and 474 views
Page 1 of 1 (3 items)
Sort Posts:
  • Mon, Aug 26 2013 12:06 PM

    • steve2fit
    • Not Ranked
    • Joined on Thu, Aug 9 2012
    • Posts 2
    • Points 25
    Allegro 3D-Viewer Bottom Component View not correct Reply

     When executing the 3D command in Allegro PCB Designer 16.6, the top components are placed correctly with the smt leads flush on the top conductor surface. However, if I rotate the design from within the viewer to look at the bottom side, the bottom component smt leads are buried in the board and are not sitting flush on the bottom conductor surface. It is almost as if the board thickness is being taken into consideration.

    Am I missing a setting?

    • Post Points: 20
  • Tue, Aug 27 2013 1:36 AM

    • oldmouldy
    • Top 10 Contributor
    • Joined on Tue, Jul 15 2008
    • Woking, Surrey
    • Posts 1,454
    • Points 24,710
    Re: Allegro 3D-Viewer Bottom Component View not correct Reply
    This issue was fixed in 16.6 hotfix 14 and later.
    • Post Points: 20
  • Tue, Aug 27 2013 5:29 AM

    • steve2fit
    • Not Ranked
    • Joined on Thu, Aug 9 2012
    • Posts 2
    • Points 25
    Re: Allegro 3D-Viewer Bottom Component View not correct Reply

     Thanks!...working fine now.

    • Post Points: 5
Page 1 of 1 (3 items)
Sort Posts:
Started by steve2fit at 26 Aug 2013 12:06 PM. Topic has 2 replies.