Home > Community > Forums > PCB Design > Bug in Constraint Manager when changing Thru Via To Shape

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Bug in Constraint Manager when changing Thru Via To Shape 

Last post Wed, Jul 3 2013 6:35 PM by aricbeaver. 2 replies.
Started by aricbeaver 02 Jul 2013 07:51 PM. Topic has 2 replies and 470 views
Page 1 of 1 (3 items)
Sort Posts:
  • Tue, Jul 2 2013 7:51 PM

    Bug in Constraint Manager when changing Thru Via To Shape Reply

    Hi,

    When I change the spacing constraint of "Thru Via to Shape" in the constraint manager the constraints seem to vanish all together on the layout until either a padstack is updated or that specific layer is changed from positive to negative and back to positive artwork. Why? Here are some pictures of before and after.

     

    • Post Points: 20
  • Wed, Jul 3 2013 2:04 AM

    • oldmouldy
    • Top 10 Contributor
    • Joined on Tue, Jul 15 2008
    • Woking, Surrey
    • Posts 1,410
    • Points 24,040
    Re: Bug in Constraint Manager when changing Thru Via To Shape Reply
    The dynamic shape details are affected by rule changes, in a complex design this could take a while to update so they remain "out of date". Use Display>Status, Update to Smooth, or Shape>Global Dynamic Parameters, shape fill tab, Update to Smooth, to get the shapes updated.
    • Post Points: 20
  • Wed, Jul 3 2013 6:35 PM

    Re: Bug in Constraint Manager when changing Thru Via To Shape Reply
    Yup, that was it. Thanks
    • Post Points: 5
Page 1 of 1 (3 items)
Sort Posts:
Started by aricbeaver at 02 Jul 2013 07:51 PM. Topic has 2 replies.