Home > Community > Forums > Custom IC Design > analog_extracted simulation

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 analog_extracted simulation 

Last post Wed, May 29 2013 3:59 AM by Andrew Beckett. 1 replies.
Started by Magistus 03 May 2013 07:52 AM. Topic has 1 replies and 498 views
Page 1 of 1 (2 items)
Sort Posts:
  • Fri, May 3 2013 7:52 AM

    • Magistus
    • Not Ranked
    • Joined on Fri, May 3 2013
    • Posts 8
    • Points 85
    analog_extracted simulation Reply

    hi,

    first: sorry for my bad english!

    i want to simulate my design by using the "analog_extracted"-layout. in the "environment options"-window i wrote "analog_extracted" at the beginning of the "switch view list"-line. if i use ADE L, then the simulation runs without any problems. but if i use ADE XL i get the message, that new variables were found {extraction, in, not, used} and i have to assign values to these variables before running simulations. i don't know where these variables come from.

    what i am doing wrong?

    thank you!

    • Post Points: 20
  • Wed, May 29 2013 3:59 AM

    Re: analog_extracted simulation Reply

    There may be something wrong in the CDF setup for some device - it suggests to me that something is being netlisted as "not used in extraction" - but it's hard to know without seeing the data.

    I suggest you contact customer support (hopefully you have by now). Alternatively, looking at the netlist you got in ADE XL might help (use Right Mouse->View Netlist over the failing point).

    Regards,

    Andrew.

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by Magistus at 03 May 2013 07:52 AM. Topic has 1 replies.