I use the 'y' layers as helpers within layout such as marking a flip point on a symmetrical cell.
Typically I'll make a path and set the width to .001; at least I used to do this until 6.1.5
Now, there is a new feature that will not allow a smaller than double manufacturing grid path so when I set the width to .001, I get this and then the width is reset to .005.
*WARNING* (LE-103007): Width of 0.005 should be an even multiple of mfgGrid (0.005) units 0. new width of 0.005
has been adjusted to even multiple of mfgGrid (0.005) units 0.
*WARNING* (LE-103836): The value for width should be greater than zero, setting it back to previous
I'm not sure why this is so important on a non-process layer and I'm wondering, before I file a "lost functionality" SR, if there is a variable that I can set to regain the old behavior.