Home > Community > Forums > PCB Design > Signal will not connect to other line or pad

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Signal will not connect to other line or pad 

Last post Wed, Aug 15 2012 12:15 AM by Crusty. 2 replies.
Started by Crusty 14 Aug 2012 11:28 AM. Topic has 2 replies and 1097 views
Page 1 of 1 (3 items)
Sort Posts:
  • Tue, Aug 14 2012 11:28 AM

    • Crusty
    • Not Ranked
    • Joined on Tue, Aug 14 2012
    • Posts 2
    • Points 25
    Signal will not connect to other line or pad Reply

     Hi,
    Please give advise why the signals don't want to connect.

    I tried every setting I found, the lines just do not want to snap to a pin or other line segment. The ratsnets showing not connected even if the line endponits are completely on each other. I replaced the components to be on grid (the footprints are OK), tryed to swich on/off "gridless" and turned "snap to pin" on/off. If I try many times, it makes the connection, but it makes me crazy.

    Is there a setting for snap to grid range?

    The companys standards are working, I should just finish a colleauges job and I can't find what he set wrong.

     thank you in advance 

    • Post Points: 20
  • Tue, Aug 14 2012 12:53 PM

    • CCR77
    • Not Ranked
    • Joined on Thu, Aug 29 2013
    • Redmond, WA
    • Posts 0
    • Points 675
    Re: Signal will not connect to other line or pad Reply

    Hello,

           Please ensure that you have Clines and or Cline Segs checked in your Design Object Find Filter.  Once checked you should connect the clines after issuing add connect command.

    -Clint

    • Post Points: 20
  • Wed, Aug 15 2012 12:15 AM

    • Crusty
    • Not Ranked
    • Joined on Tue, Aug 14 2012
    • Posts 2
    • Points 25
    Re: Signal will not connect to other line or pad Reply

    Thanks, that was it...

    Design Object Find Filter changes its setting in the function "Add connect".

    • Post Points: 5
Page 1 of 1 (3 items)
Sort Posts:
Started by Crusty at 14 Aug 2012 11:28 AM. Topic has 2 replies.