Home > Community > Forums > Hardware/Software Co-Development, Verification and Integration > Problems creating artwork for a split plane.

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Problems creating artwork for a split plane. 

Last post Thu, Aug 23 2012 2:07 AM by girish. 1 replies.
Started by BGLuther 27 Jun 2012 06:57 AM. Topic has 1 replies and 2788 views
Page 1 of 1 (2 items)
Sort Posts:
  • Wed, Jun 27 2012 6:57 AM

    • BGLuther
    • Not Ranked
    • Joined on Thu, Mar 15 2012
    • Ivyland, NJ
    • Posts 1
    • Points 20
    Problems creating artwork for a split plane. Reply

    I created a split negative plane for the power layer. When I create artwork, the split line comes in as a negative line, invisible except where it crosses anti-pads. The line is on the AntiEtch-Power layer and I ran the Edit-Split Plane-Create command. All of the clearances and thermals are in the appropriate locations in relation to the split.

       Regards,

            Brandon Luther

    • Post Points: 20
  • Thu, Aug 23 2012 2:07 AM

    • girish
    • Top 25 Contributor
    • Joined on Wed, Jul 16 2008
    • Bangalore, Karnataka
    • Posts 241
    • Points 4,920
    Re: Problems creating artwork for a split plane. Reply

    Check Xsection & Plot mode in Manufacture->artwork

    Better you can define planes as +ve plane . it gives more flexibity on controls

     Regards,

    Girish Kumar 

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by BGLuther at 27 Jun 2012 06:57 AM. Topic has 1 replies.