Home > Community > Forums > RF Design > inductor q factor simulation?

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 inductor q factor simulation? 

Last post Thu, Aug 11 2011 3:07 AM by Andrew Beckett. 1 replies.
Started by hwangjongil 11 Aug 2011 02:34 AM. Topic has 1 replies and 3628 views
Page 1 of 1 (2 items)
Sort Posts:
  • Thu, Aug 11 2011 2:34 AM

    inductor q factor simulation? Reply

    I want Q factor smulation of inductor .

     but I can't do s parameter simulation.

     I progressed to pick "spectreS " in analog design environment.

     when i simulated inductor, i can't select s parameter.. in direct plot ..

     what is problem?

    Filed under:
    • Post Points: 20
  • Thu, Aug 11 2011 3:07 AM

    Re: inductor q factor simulation? Reply

    First of all, why are you using "spectreS"? It was replaced by the "spectre" interface in IC443, which came out something like 12 years ago. It is no longer available in IC61. 

    However, I just tried this in IC5141, placing a couple of port components (e.g. the old "psin" component; don't think "port" is supported for spectreS), setting up an sp simulation, and then I could plot the s-parameters etc on the direct plot form.

    I suggest you read the Forum Guidelines - you didn't give any information about any errors, or precisely what you did - or even which version you're using. So it's very hard for anyone to help.

    Regards,

    Andrew.

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by hwangjongil at 11 Aug 2011 02:34 AM. Topic has 1 replies.