Home > Community > Forums > IC Packaging and SiP Design > Power/Ground Nets

Email
* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

Cadence Contacts

Global Office Locator
Find Offices worldwide »

Sales Inquiry
Request for Product information »
Cadence Channel Partners »

Corporate Headquarters
Cadence Design Systems, Inc.
2655 Seely Avenue
San Jose, CA 95134
Phone: 408.943.1234
* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Power/Ground Nets 

Last post Tue, Apr 5 2011 5:41 PM by ICPACK. 0 replies.
Started by ICPACK 05 Apr 2011 05:41 PM. Topic has 0 replies.
Page 1 of 1 (1 items)
Sort Posts:

  • Tue, Apr 5 2011 5:41 PM

    • ICPACK
    • Not Ranked
    • Joined on Fri, Sep 24 2010
    • Posts 2
    • Points 10
    Power/Ground Nets Reply

    Hello,

    I'm a newbie in APD and trying to route a flip chip design. I have imported the die information into the design and got the BGA set up. So now, I have the bumps , balls and blind/buried vias definitions set up. I am stuck at this point where I have to assign the power/ground nets to the power/gnd solder balls. I assigned the rest of the signal nets through the auto assign command. I have around 15 power planes. Any advice/help will be greatly appreciated.

    Thanks in advance.
    • Post Points: 5
Page 1 of 1 (1 items)
Sort Posts:
Started by ICPACK at 05 Apr 2011 05:41 PM. Topic has 0 replies.