Home > Community > Forums > Digital Implementation > How to Match Routing wire length?

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 How to Match Routing wire length? 

Last post Mon, Aug 16 2010 10:16 AM by Kari. 1 replies.
Started by Sundarsan 05 Jul 2010 03:22 AM. Topic has 1 replies and 1541 views
Page 1 of 1 (2 items)
Sort Posts:
  • Mon, Jul 5 2010 3:22 AM

    • Sundarsan
    • Not Ranked
    • Joined on Wed, Nov 25 2009
    • Posts 2
    • Points 40
    How to Match Routing wire length? Reply

    Hi,

    I have a 8Bit Data path, each path has equal number of buffers.

    The buffers are placed at equal distance, now when i route the signals, all the signals should have equal wire length.

    The Signal in the same path and the signals in the other 8bit paths should have equal wire length after routing.

    How to achive this using Nano route?  Is there any special switch or setting to achieve this wire length matching?

    Thanks in Advance,

    Sundar

     

    • Post Points: 20
  • Mon, Aug 16 2010 10:16 AM

    • Kari
    • Top 10 Contributor
    • Joined on Tue, Jul 15 2008
    • Cary, NC
    • Posts 693
    • Points 14,155
    Re: How to Match Routing wire length? Reply

     Try routing these nets first. You can select the nets, run nanoRoute on selected nets only, then route the rest of the design.

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by Sundarsan at 05 Jul 2010 03:22 AM. Topic has 1 replies.