Home > Community > Forums > PCB Design > Setting up blind/buried vias, via-in-pad

Email

* Required Fields

Recipients email * (separate multiple addresses with commas)

Your name *

Your email *

Message *

Contact Us

* Required Fields
First Name *

Last Name *

Email *

Company / Institution *

Comments: *

 Setting up blind/buried vias, via-in-pad 

Last post Tue, Apr 27 2010 2:13 PM by girish. 1 replies.
Started by EdJP 23 Apr 2010 11:59 PM. Topic has 1 replies and 5931 views
Page 1 of 1 (2 items)
Sort Posts:
  • Fri, Apr 23 2010 11:59 PM

    • EdJP
    • Not Ranked
    • Joined on Sat, Apr 3 2010
    • Chelmsford, MA
    • Posts 1
    • Points 20
    Setting up blind/buried vias, via-in-pad Reply

    What is the best/correct way to set up a design for using blind and buried vias and via-in-pad (adding them to the board, setting up DRC's and CM, using them, etc)?  I'm reading the available HDI docs but it seems that some of the details aren't covered. (16.2)  Thanks!  

    Filed under: , ,
    • Post Points: 20
  • Tue, Apr 27 2010 2:13 PM

    • girish
    • Top 25 Contributor
    • Joined on Wed, Jul 16 2008
    • Bangalore, Karnataka
    • Posts 241
    • Points 4,920
    Re: Setting up blind/buried vias, via-in-pad Reply

    hi,

    Refer the below thread may be usefull

     

    https://www.cadence.com/Community/forums/p/11435/14248.aspx#14248

    Regards,

    Girish Kumar

    • Post Points: 5
Page 1 of 1 (2 items)
Sort Posts:
Started by EdJP at 23 Apr 2010 11:59 PM. Topic has 1 replies.